Blaze LTE PRO Built-In Power Burner W/ Stainless Steel Lid - BLZ-PBLTEPRO

Features

• 60,000 BTU, two rings: 25,000 BTU inner ring for simmering and 35,000 BTU outer ring for high heat, with independent controls.
• Wok-ready grid: heavy-duty stainless steel rod grid (13-1/4" x 17") with a removable center ring for a wok.
• LTE PRO lighting: LED-backlit knobs with safety glow that show gas-on status and match LTE PRO grills and griddles.
• Slim 15-3/4" width: leaves more of the island for other components or counter space.
• Wind guard and cover: a stainless guard keeps wind off the flame, and a removable stainless cover protects the burner between uses.
• Easy cleanup: full-width pull-out drip tray.
• Lifetime coverage on the core: burners, grate, body and valves carry a Blaze lifetime residential warranty (parts) when registered.

Specifications

Installation planning

• Cut-out: 14" W x 19-1/2" D x 9-1/4" H. The opening must not be larger than the burner's outer frame: the unit rests on its frame lip. Notch the countertop if it overhangs the island face, and cut a 1" air gap in the front face of the countertop below the control panel.
• Install in a non-combustible enclosure only; the local fire marshal, building inspector or authority having jurisdiction decides what counts as combustible. A combustible island needs the Blaze insulated jacket.
• Keep 18" between the sides and back of the burner and any combustible material (4" to non-combustible construction). Do not install under combustible overhead construction; a non-combustible overhead needs 72" of clearance and a vent hood of at least 1,000 CFM, larger than the cooking area.
• Vent the island on both sides: upper vents with their top edge within 5" of the island top (1 sq. in. of free area per lb of stored fuel, per vent) and lower vents within 1" of the floor and no more than 5" high (1/2 sq. in. per lb, per vent). Every opening must pass a 1/8" rod. Propane is heavier than air and natural gas is lighter, so both vent levels matter.
• Outdoors means up to three walls with no roof, or a roof with no more than two walls; windows, doors and screens do not count as permanent openings.
• Gas: natural gas runs at 4" water column through the supplied regulator; propane runs at 11" water column through the factory hose and regulator (3/8" flare; no pipe sealant on flare fittings; hand-tighten the regulator to the cylinder). Inlet pressure above 1/2 psi needs another regulator. The installer supplies an accessible shut-off valve (Massachusetts requires a T-handle valve). Keep only one 20 lb cylinder with an overfill prevention device in a base cabinet.
• Fuel conversion between natural gas and propane is for a licensed gas professional only (regulator pin, burner orifices with a 6 mm socket, and air shutter: about 1/8" open for natural gas, 1/4" for propane, for a mostly blue flame).
• Electrical: plug the light transformer into a 15-amp GFI-protected circuit; outdoor extension cords must be rated "W" or "W-A". The light power button on the lower right side of the control panel glows red when on. Disconnect the transformer before cleaning.
• Leak-test every connection with a 1:1 soap and water solution before each use, after installation and whenever a connection or cylinder is changed. Never use a flame to check for leaks.
• Lighting: remove the cover, push the knob in and turn it to HIGH. If it does not light within 5 seconds, turn it off and wait 5 minutes before trying again.

Care: Clean after every use once cool. Brush the grid, then wipe it with a 50/50 vinegar and water solution; never flood a hot grid with cold water, and oil it lightly once dry. Empty and wash the drip tray in hot soapy water after each use. Wipe the stainless steel along the grain with a stainless steel cleaner and never cover a damp or warm unit. Check the burner tubes for insect nests and debris before each use.

Warranty

Blaze residential warranty, parts only: lifetime on the main burners, grates, body, valves, stainless steel components and flame stabilizers; 1 year on the ignition and on the lighting and electrical parts. Multi-user installations get 3 years on the stainless housing, burners, rod grids, brass valves, inner liners and manifolds and 90 days on other components; restaurant use is not covered. The warranty covers the original owner at the original site and does not transfer. Register with Blaze within 30 days of purchase and keep your receipt. Labor, shipping, handling and diagnostic charges are not covered, nor are discoloration or surface rust (unless structural integrity is lost), damage from poor maintenance, chemicals, chlorine or salt, unqualified installation, unregulated gas or unapproved accessories. Coverage applies in the United States and Canada. Full terms are in the manual.

Manuals and documents

• Blaze LTE+ and LTE PRO power burner manual, BLZ-PBLTE3 / BLZ-PB-LTEPRO (PDF)
• Blaze product page: LTE PRO Power Burner
• Blaze product registration

Legal disclaimers and warnings

Product packaging, owners' manuals, installation instructions, and/or operating instructions may include more information than what is shown on our website. The content on our site is intended to be used for reference purposes only. Please fully read all included manuals and documentation before installing or using this product. WARNING: This product can expose you to chemicals including chromium (hexavalent compounds), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.