

















Features
- 80,000 BTU total: five 14,000 BTU cast stainless steel linear burners plus a 10,000 BTU infrared rear burner for rotisserie cooking.
- Five heat zones: a 670 sq. in. main grid divided by removable heat zone separators, plus a 227 sq. in. warming rack (897 sq. in. total).
- Stainless steel rod grids: heavy-duty stainless steel cooking rods across all five heat zones.
- Fewer flare-ups: perforated, full-coverage flame-stabilizing grids also shield the burners below.
- Double-lined hood: the inner liner protects the outer hood from heat discoloration and holds steady, high heat.
- Night grilling: red LED-illuminated control knobs and interior grill lights.
- Dependable ignition: Push N' Turn flame-thrower ignition, with a flash tube as backup.
Blaze 40-inch Premium LTE (BLZ-5LTE2) vs LTE+ (BLZ-5LTE3)
| Premium LTE, BLZ-5LTE2 (this grill) | Premium LTE+, BLZ-5LTE3 | |
| Burners | 5 x 14,000 BTU + 10,000 BTU infrared rear | 5 x 14,000 BTU + 10,000 BTU infrared rear |
| Total output | 80,000 BTU | 80,000 BTU |
| Main grid | 37-1/4" x 18", 670 sq. in., 5 zones | 37-1/4" x 18", 670 sq. in., 5 zones |
| Cut-out | 38-3/8" W x 21-1/4" D x 8-1/2" H | 38-3/8" W x 21-1/4" D x 8-1/2" H |
| Hood | Double-lined 304 stainless steel | Double-lined 304 stainless steel, spring-assisted |
| Lighting | Red LED-illuminated knobs; interior grill lights | Red LED-backlit knobs; halogen interior lights that switch on automatically |
Specifications
| Brand | Blaze |
|---|---|
| Series | Premium LTE |
| Model | BLZ-5LTE2-LP (propane) / BLZ-5LTE2-NG (natural gas) |
| Type | 40-inch built-in gas grill |
| Overall size | 39-1/2" W x 25-3/4" D x 21-1/4" H |
| Cut-out | 38-3/8" W x 21-1/4" D x 8-1/2" H |
| Main burners | 5 cast 304 stainless steel, 14,000 BTU each (70,000 BTU) |
| Rear burner | Infrared rotisserie burner, 10,000 BTU |
| Total output | 80,000 BTU (23.44 kW) |
| Cooking grid | 37-1/4" x 18", 670 sq. in., 5 zones |
| Warming rack | 227 sq. in., removable |
| Total cooking area | 897 sq. in. |
| Cooking grates | Stainless steel rods |
| Flame control | Stainless steel tri-baffle flame-stabilizing grids; removable heat zone separators |
| Ignition | Push N' Turn flame-thrower; flash tube backup |
| Hood | Double-lined 304 stainless steel, with temperature gauge |
| Lighting | Red LED-illuminated control knobs; interior grill lights (transformer powered) |
| Construction | 304 stainless steel |
| Gas pressure | Natural gas 4" water column; propane 11" water column; maximum inlet 14" water column |
| Electrical | Transformer for the lights, on a 15-amp GFI-protected circuit |
| Clearances | 18" to combustible construction; 72" to overhead construction with a vent hood |
| Warranty | Lifetime on burners, cooking grids, body and valves; 1 year on ignition, electrical and lighting (registration within 30 days) |
What's included
- 40-inch built-in grill head with hood, burners and rear infrared burner
- Stainless steel rod cooking grates and removable warming rack
- Flame-stabilizing grids and heat zone separators
- Full-width roll-out drip tray
- Light transformer
- Propane models: LP hose and regulator (BLZ-LP-HOSE/REG)
- Natural gas models: regulator set to 4" water column
Sold separately
- 40-inch rotisserie kit (BLZ-5-ROTIS-SS) for the rear burner
- Insulated jacket for 40-inch 5-burner grills (BLZ-5-IJ), required in a combustible island
- 5-burner grill cart (BLZ-5-CART-SC) for freestanding use
- Stainless steel smoker box (BLZ-SMBX), listed by Blaze for LTE grills
- Ceramic flame tamers, set of 5 (BLZ-CRM-TMR5), listed by Blaze for LBM, LTE and LTE+ grills
- Wind guard for 40-inch 5-burner grills (BLZ-WG-40)
- Drip tray flame guard for 5-burner grills (BLZ-5-DPFG)
- LED light kit for the 5-burner LTE (BLZ-5LTELED), amber or blue
- Replacement LP hose and regulator (BLZ-LP-HOSE/REG)
Installation planning
- Cut-out: 38-3/8" W x 21-1/4" D x 8-1/2" H. Overall size: 39-1/2" W x 25-3/4" D x 21-1/4" H. The manual shows the extra room the hood needs to open.
- Build into a non-combustible enclosure, or use a Blaze insulated jacket. Cut a 1" air gap in the front face of the countertop below the control panel.
- Clearances: 18" from combustible construction at the sides and back; 4" from non-combustible construction. Never install under combustible overhead construction. Under a non-combustible overhead, keep 72" and run a UL-listed vent hood of at least 1,000 CFM that is larger than the cooking area, with the fan bottom 36" above the cooking surface.
- Island vents on both sides: propane (heavier than air) needs lower vents with their bottom within 1" of the island floor and top no more than 5" up, each at least 1/2 sq. in. of free area per lb of stored fuel; natural gas needs upper vents within 5" of the island top, each at least 1 sq. in. per lb of stored fuel. Openings must admit a 1/8" rod and stay unobstructed.
- Propane: one standard 20 lb cylinder (12-1/4" diameter x 18" high, with overfill protection device) at a time; connect the 3/8" flare hose fitting with a wrench and no pipe sealant. Natural gas: Blaze recommends a flex connector of at least 5/8" diameter, run to the regulator at the rear right corner, with an accessible shut-off valve.
- Electrical: mount a 15-amp outlet on a GFI-protected breaker inside the island (back wall); the light transformer plugs into it. Outdoor-rated extension cords only.
- Two people should lift the grill into the cut-out; check it sits level and is supported around its full edge (non-combustible shims if needed). A permit may be required. Fuel conversion (LP to NG or back) is done only by a licensed gas professional: new orifices on each burner plus the regulator pin.
- With an insulated jacket: a licensed contractor installs it, gas connections inside it use a stainless steel flex line (never a rubber hose), and the grill's own clearances above, behind and beside still apply.
- Leak-test every connection with soapy water before first use and whenever a connection changes; never use a flame.
Care: Inspect and clear the burner tubes before each use (insects can nest in them and cause a flashback). Flames should be mostly blue and not lift off the burner; the air shutter is set about 1/8" open for natural gas and 1/4" for propane. After each cook, brush the grates on medium-high, wipe them with a 50/50 vinegar and water solution, then dry and oil lightly; empty and wash the drip tray once cool and never cook without it. Clean stainless steel with the grain using a non-metallic pad, never flood a hot grill with cold water, and cover it only when cool and dry.
Warranty
Blaze lifetime warranty (parts only) on the main burners, cooking grids, body, stainless steel components, flame stabilizers and control valves; 1 year (parts only) on ignition, electrical and lighting components, from the purchase date. For multi-user use, Blaze covers the stainless steel housing, burners, rod grids, brass valves, liners and manifolds for 3 years and other parts (except burners) for 90 days; restaurant use is not covered.
The warranty covers the original owner at the original installation site in the United States and Canada and is not transferable. Register the grill with Blaze within 30 days of purchase and keep your receipt. Labor, shipping and diagnostic charges are not covered, and discoloration or surface rust is excluded unless structural integrity is lost. Improper installation, unqualified repairs or unapproved alterations void the warranty. Full terms are in the grill manual below.
Frequently asked questions
How many BTUs does the Blaze 40-inch 5-burner LTE gas grill have?
80,000 BTU in total: five 14,000 BTU cast stainless steel burners (70,000 BTU) plus a 10,000 BTU infrared rear burner for rotisserie cooking.
What cut-out does the BLZ-5LTE2 need?
38-3/8" W x 21-1/4" D x 8-1/2" H, in a non-combustible island. In a combustible island, fit the BLZ-5-IJ insulated jacket.
Is it available for natural gas and propane?
Yes. BLZ-5LTE2-NG is the natural gas model and BLZ-5LTE2-LP is the propane model, which ships with the LP hose and regulator. A conversion later must be done by a licensed gas professional.
Will the Blaze LTE+ (BLZ-5LTE3) fit the same opening?
Yes. Both 40-inch grills use the same 38-3/8" x 21-1/4" x 8-1/2" cut-out and the same burner layout; the LTE+ adds a spring-assisted hood and automatic halogen interior lights.
Manuals and documents
- Blaze Premium LTE+ and LTE grill manual, version 7/16/2025, covers BLZ-5LTE2 (PDF)
- Blaze insulated jacket installation (PDF)
- Blaze 2025 product catalog, LTE gas grill page (PDF)
Legal disclaimers and warnings
Product packaging, owners' manuals, installation instructions, and/or operating instructions may include more information than what is shown on our website. The content on our site is intended to be used for reference purposes only. Please fully read all included manuals and documentation before installing or using this product. WARNING: This product can expose you to chemicals including chromium (hexavalent compounds), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.